REALITi 360 version 11.15.0 is live!
Latest Improvements in REALITi 360 Version 11.15.0
Atlas
- Fixed manikins on old firmware not getting the correct type
- Additional checking of manikin types
- Depth parameter changes with multiple CPR devices attached
- Fixed timeout
- Increased timeout to 7 seconds for Atlas Baby, Junior, AdultGen3
- Fixed pulse level setting not reflecting pulse level
- CPR artefacts appear on ECG trace when using Atlas
- SpO2 waveform changes to Poor Perfusion when ventilation or compression is started
Camera
- Fixed waveforms not running on the camera screen
Corpuls
- Removed energy escalation protocol settings (C1, C3)
- Improved C1 invert display
- Stopwatch responds to scenario pauses and resumes
- Fixed C1 QRS tone disappearing when in either defibrillator or pacer modes, and C3 QRS tone disappearing when switching from home screen to defib modes
- Analyze and Charge buttons activate AED and Manual Defibrillator modes
- Fixed CPR button showing no artefacts on the Pacing rhythm
- Pacer off prompt appears while pacing is on when changing from Monitor mode to AED or Manual defibrillator
- Resolved “Connect pacer cable” appearing in C1
- Removed middle soft key option at the start of AED, including during CPR phase, and second soft key option ‘Manual’ to ‘Energie’ in Manual mode
- Adjusted the visible soft key options in Manual mode—when charging or fully charged—to display only Energy, Cancel, and Monitor, in both English and German.
- Resolved Metronome setting text in AED and Manual modes
- Resolved pacing rhythm in Demand mode when only pads are on
- Extra checks on RA or LL electrodes as part of the pacing rhythm state to ensure it affects pacing rhythm
- Corrected pacing rhythm not affected by pads when off
- Improved how the rhythm with pacing reacts when either electrodes or pads are removed and then re-attached
- Fixed text prompt for Pacing when switching to defib
- Fixed ‘Switch off Pacer?' transitions when the switch is cancelled while electrodes are off
- Added translation ‘Schrittmacher ausschalten?’
- Fixed C1 audio doubling voice prompts
- Improved C1 Views
Hamilton T1
- Removed ‘Connect Ventilator’ button
- Fixed default Delta P value
- Fixed spontaneous breath marker not being removed at start and end of trace
- Spont TI is automatically calculated
- Improved calculations of default TI when changing Adult IBW or Neonatal Weight
- Improved IBW/weight calculation for the Vt alarm limit
- Improved the SPONT mode by disabling the option and setting value to 0 in Ventilator settings
- Fixed Pressure cmH2O alarm limits on high and low for Neonatal and Adult
- Improved alarm ExpMinVol default limits’ calculation from weight/IBW, Vt and Rate
- Corrected ExpMinVol low and high limit values for each patient type
- Fixed ExpMinVol low and high limits where it skips the maximum limit value
- Fixed fTotal high and low limits, showing Adult limits instead of Neonatal
- Fixed Vt limit low value skipping value 10 before the Off symbol for Adult
- Fixed Vt limit high value to show maximum of 3000 for Adult before the Off symbol
- Fixed Vt limit high value to show maximum of 300 for Neonatal before the Off symbol
- Fixed Vt limit low value to show maximum of 0.1 for Neonatal before the Off symbol
- Improved Vt limit low value calculation based on weight or IBW
- Fixed Alarms limits where the high value can get lower than the low value
- Improved Rate and TI values
- Fixed dial subtext
- Improved TI max dot
- Added indicator for Nebulizer when it’s active
- Added message “Nebulizer is active”
- Created 10-sec timer for the generic message display
- Added a stop action for the Nebulizer to remove message and turn off light indicator
Facilitator/Control
- Fixed primary folder appearing empty when it’s not
- Added multiple lines for scenario names
Generic
- Fixed Sync not getting disabled after a shock
Nihon Kohden - EMS1052
- Improved Japanese translations
Philips MRX
- Display CPR waveform on all leads when CPR is active
Teaching Management System (TMS)
- Fixed data computation, compression depth guide, and compression target rendering during CPR
Zoll X Advanced
- Adjusted label sizes so translations fit appropriately